Maintenance And Cleaning Instructions; Replacing The Carbon Brushes; Lubrication; Cleaning And Storage - VITO PRO POWER VISCME305 Mode D'emploi

MAINTENANCE AND CLEANING INSTRUCTIONS

Before performing cleaning, adjusting, repairing and
maintenance work, switch the appliance off and unplug
the power cord. Wait for the blade to stop completely.
The saw does not require any additional lubrication or
maintenance. However, you must perform regular cleaning for
a continuous and trouble-free operation.
Always keep saw blades clean and sharp. Properly maintained
blades jam less frequently, are more easily controlled and allow
greater efficiency during use of the appliance.

Replacing the carbon brushes

The motor will not start if the carbon brushes are worn out. The
brushes must be replaced in time, otherwise there will be poor
contact between the brushes and the rotor, which may lead to
sparks and damage to the tool. The two brushes should be
replaced at the same time by two brushes with equal
characteristics.
1. Loosen the fixing screws on the carbon brushes cover (4);
2. Remove the worn-out carbon brushes and insert the new
ones;
3. Place the carbon brushes cover and tighten the screws;

Lubrication

The moving parts of the power tool (slide rail and spindles) must
be kept constantly greased to ensure the best performance and
the expected service life.
Lubrication should be frequent, but not excessive. Apply only a
few drops of grease, after each use, to ensure power tool's good
performance.

Cleaning and storage

Cleaning
You can get information regarding the disposal of the power
tool through the person in charge for recycling in your city.
After each use, clean all the components of the sliding miter
saw. Wipe the power tool with a clean, damp cloth or blow it
with low pressure compressed air.
Careful handling protects the power tool and extends its service
life.
Storage
When not in use, store the sliding miter saw in a dry, clean place,
free of corrosive smoke and out of children's reach.

ENVIRONMENTAL POLICY

The packaging is made up of recyclable materials, which
you can dispose on local recycling points.
Never dispose of power tools with your household
waste!
According to the European Directive 2012/19 /EC on electrical
and electronic equipment waste and its transposition into
national law, power tools must be collected separately and
delivered to the collection sites provided for this purpose.

CUSTOMER SERVICE

Tel.: +351 256 248 826
E-mail: international@centrallobao.pt
Site: www.centrallobao.pt
35