Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
PKPT100XX
PSI Woodworking Products
Presimo
REQUIRED ACCESSORIES:
• 7mm Pen Mandrel
• 2 piece Bushing Set #PKPT100BU
• 10mm Drill Bit #PK10-10
• Universal Trimming Kit #PKTRIMKIT (use 10mm shaft)
• Replacement Roller Refill #PK10-RPR
• Replacement Ink Cartridge #PK10-FPR
• 2 part epoxy glue or insta-cure (cyanoacrylate) glue
• Overall length 5-1/2" (closed)
DIAGRAM A • Parts List
End Cap
Coupler
Upper Cap
Tube
Roller Ball Tip
Roller Ball Refill
Spring
Ink Pump
Ink Cartiridge
Fountain Nib Assembly
PREPARING THE BLANK:
• Cut 3/4" square blank to the length of the brass tube (add 1/16" for squaring off).
• Drill a 10mm center hole lengthwise through the blank.
• Spread the glue over the tube. Insert the tube into the blank with a twisting motion to spread the glue
evenly inside. Center the tube lengthwise in the blank.
• When the glue dries, square the ends of the blank. Use 10mm barrel trimmer, a universal pen blank
squaring jig or a belt/disc sander to square the ends. Take the wood down flush to the brass tube.
DIAGRAM B • Turning the blank
Lock Nut
Finished Barrel
Headstock
End Bushing
End Bushing
Live Center
7mm Spacers
Mandrel
7mm Spacer
Pen Blank
Publicité
Manuels Connexes pour PSI Woodworking Products Presimo
Sommaire des Matières pour PSI Woodworking Products Presimo
- Page 1 PKPT100XX PSI Woodworking Products Presimo REQUIRED ACCESSORIES: • 7mm Pen Mandrel • 2 piece Bushing Set #PKPT100BU • 10mm Drill Bit #PK10-10 • Universal Trimming Kit #PKTRIMKIT (use 10mm shaft) • Replacement Roller Refill #PK10-RPR • Replacement Ink Cartridge #PK10-FPR • 2 part epoxy glue or insta-cure (cyanoacrylate) glue •...
- Page 2 PKPT100XX PSI Woodworking Products TURNING THE BLANK: • Place bushings and blank on the mandrel according to Diagram B. • Thread on the lock nut and hand tighten to hold all items in place. • Slide the tailstock to the mandrel shaft, (do not overtighten, it could damage the mandrel).
- Page 3 Traduction des instructions de Penn State Industries (PSI) pour stylo Presimo Presimo Presimo REQUIRED ACCESSORIES: MATÉRIEL REQUIS : • 7mm Pen Mandrel • Mandrin pour stylo de 7 mm • 2 piece Bushing Set #PKPT100BU • Jeu de deux bagues n PKPT100BU •...
- Page 4 Traduction des instructions de Penn State Industries (PSI) pour stylo Presimo not overtighten, it could damage the trop de force, car cela risque d’endommager le mandrin); verrouillez en mandrel). Lock in place. position. • Turn the wood down, flush with the •...