Publicité
Les langues disponibles
Les langues disponibles
Installation
3
Outlet Hose
Water OUT
Water IN
NOTE: If you don't get water in
30 seconds or less, refill the hose
and repeat the process.
INLET HOSE GOES IN THE
WATER; OUTLET HOSE STAYS
OUT OF THE WATER. MOTOR
MUST STAY DRY
To prime the pump, fill the suction hose
with water, put it back in the water source,
dry your hands, and start the pump.
Make sure all inlet connections are tight
(no air leaks) and the inlet hose is in the
water. Make sure the end of the outlet hose
is not under water. If the outlet is under
water, the pump may not work.
Plug the cord into a 3-wire, 115 volt,
60 Hz, grounded A.C. outlet.
You should get water in 30 seconds or less.
If not, refill the hose and repeat the
process. If your pump does not prime on
the second try, check the impeller and the
inside of the pump head for wear. Replace
as needed.
The motor must have air circulation
around it for proper cooling. This pump
will lift water 12'; trying to lift water more
than 12' can cause the motor to run hot.
The motor has a thermal overload which
will stop it if it gets too hot. If the motor
stops, allow it to cool for 30 minutes
before trying to start it again.
Plug in pump to start it.
Inlet Hose
N
4
UNPLUG THE PUMP
Unplug the pump before all the water is
completely gone.
DO NOT RUN PUMP DRY!
PERFORMANCE
The pump will deliver 350 gallons/1325
liters per hour with an unrestricted dis-
charge line. If the discharge line is restrict-
ed or raised and the pressure on the pump
outlet port increases, it will pump less
water.
NOTICE: This pump's motor has brushes.
Inspect the brushes frequently; replace
them if they're worn.
4
Unplug
Publicité
