Publicité
Les langues disponibles
Les langues disponibles
Installation
1
1/2" or Larger
Outlet Hose
Water OUT
Water IN
USE 1/2" HOSE (OR LARGER)
Use a reinforced hose on the inlet. The
pump should be less than 10' above and
less than 25' to one side of the water
source. Make the outlet hose as short as
possible – 25' or less.
Check the washer in the inlet fitting to
make sure it is airtight. If this joint leaks
air, the pump will not operate.
DO NOT RUN THE PUMP DRY!
Mount the pump solidly on a stable
platform.
1/2" or Larger
Reinforced
Inlet Hose
KEEP THE HOSES AS STRAIGHT
AS POSSIBLE
To reduce friction, do not coil or kink the
hoses. When pumping from a well or
stream, raise the inlet hose a few inches off
the bottom to avoid sucking in sand, silt or
pebbles (which can disable the impeller).
Install the suction attachment (included) to
protect the pump from large solids .
NOTICE: Attach the suction attachment to
the end of the inlet line and place it in at
least 1/2" of water at the lowest point to be
pumped. Be sure all connections are air tight.
2
Straight
Hose!
No kinks!
3
No Coils!
Publicité
