Table des Matières
Publicité
sigfox REFERENCE TRANSMITTER - Guide utilisateur / User guide version V1.0.0
3.2. Closing the casing
Once previous stages have been carried out, you can close the casing of the sigfox REFERENCE TRANSMITTER
Procedure:
1. Make sure that the seal is properly positioned on the base
2. Clip the electronic board onto the casing's base. Make sure that the fastening clip is properly locked into the
board's fitting.
3. Insert the upper part of the casing. Inside this part there are guide rails for the board. Make sure that the
FR
EN
board is properly positioned within these guides.
4. Once the board is in position, lower the upper cover and lock it onto the casing's base. Strong pressure will
enable both parts to be clipped together and will enable protection level IP67 to be ensured.
1
2
Fitting
Fastening
clip
3/4
Locking clips for
the upper casing
Seal
Page
Page
16
16
of 30
of 30
Publicité
Table des Matières
