Proscenic COCO Smart 790T Mode D'emploi page 9

Starting Up / Standby / Sleeping / Power Off
1. Starting up
a. Make sure the power switch is on(The power switch is at the right side
of main body)
b. In standby mode, press
to start cleaning.
Note:
If robot is in sleep mode, press
mode, then press
2. Standby
Standby means robot has its power switch on, waiting for the user's
operation. It can be changed to standby mode by one of the following
methods:
a. During robot cleaning, press
b. During robot cleaning, press ON/OFF button on remote control to po
-wer off the robot.
3. Sleep
In sleep mode, the robot can only be waken up from
body or ON/OFF on remote control. In order to save power, you can turn
the robot into sleep mode from standby mode via either of the following
methods:
a. Press on main body and hold it for 3 seconds.
b. Robot will automatically enter sleep mode if no command is received
for more than 2 minutes
How to schedule the robot
1. Schedule on Display Panel on Main Body
A. Setting robot clock (Make sure the robot is in standby or
power on status)
a. Press"Schedule"button to start clock-setting. the LED panel will
show the current system time.
b. Then the left two numbers on LED panel will flash .Press"
increase hour or clean to decrease it.
Product Operation
on main body or ON/OFF on remote control
on main body to wake up the robot from sleep
again, the robot will start cleaning automatically.
on main body to enter standby mode.
"
"
8
button on main
" to
Charging