Scheduling - Proscenic COCO Smart 790T Mode D'emploi

c. Press to enter minute-setting mode, the right two numbers on LED
panel will flash. Press
d. Press button to save the setting, then press "schedule" to exit
(Before the setting is saved, if press "Schedule" to exit, the current
setting will be invalid).
B. Setting the scheduling time (Make sure the robot is in
standby or power on status)
a. Press "schedule" and hold it for 3 seconds to start scheduling, then
the left two numbers on LED panel will flash.
b.Press "
Charging
-se it.
c. Press to enter minute-setting mode, the right two numbers on LED
panel will flash, press
button to decrease it.
d. Press again to save the setting, then press "Schedule" button to
exit (Before the setting is saved, if press "Schedule" to exit, the
current setting will be invalid).
C. Cancel the scheduling
Set the scheduling time to 00:00.
Note:
a. Before scheduling, please set the robot time to be the same with real time.
b. The robot will start cleaning at the schedule time of Robot Clock every day.
Schedule has to be reset again after the power switch has been turned off.
2. Schedule on Remote Control
A. Scheduling Setting
a. Make sure the robot is in standby or charging status. Press"Schedule"
button on remote and hold it for 3 seconds to enter scheduling mode.
b. Then numbers on LED screen on the remote will flash. Change flash
-ing numbers by pressing "Up" or "Down" button. Press "Left/
Right"button to set next digit when finishing the setting of previous
digit.
c. When finish setting, with the remote pointing to the robot, press
"ON/OFF"button on remote. Display panel will show corresponding
time when it's been scheduled successfully.
Product Operation
"
" to increase it or "Clean" to decrease it.
Charging
button to increase hour or "Clean"button to decrea
"
"
Charging
button to increase it or "Clean"
"
9