Carson Expert Charger All Rounder 4A Manuel D'instructions page 7

SAFETY PRECAUTIONS
Please note the following safety instructions. Failure to do so may
result in serious damage to the charger and batteries.
• Do not store the charger at temperatures below 5°C or over
50°C.
• Keep the charger away from dust, moisture, rain, heat, direct
sunlight and vibrations. Do not drop.
• Only use this charger on heat-resistant, non-flammable,
non-conductive surfaces. Never place it on carpets, car seats or
similar surfaces.
• Only charge power packs indicated in the instructions.
• Do not use a voltage or charge higher than that stipulated by
the manufacturer of the battery pack.
• Check carefully that the charger is set to the correct battery type
(e.g. LiPo, NiMh ) and the applicable technical specifications (e.g.
number of cells, voltage).
TECHNICAL DATA
500606088 4A charger:
Input voltage: 110-240V
Type of battery: Lithium, NiMH
Number of cells:
Lithium 2-4s
NiMH 4-8s
Maximum charging current: 4A
Maximum output power: 30W
Automatic switch-off: yes
NOTICE BATTERY TYPE
"NiH" - NIMH Nickel Metal Hydride
"LPo" - LiPo Lithium Polymer
"LFE" - LiFe Lithium Ferrite
WARNING !!
Selection mode "LiH" is only suitable for lithium rechargeable batteries with an end-of-charge voltage of 4.35V.
This function cannot be used for any other type of battery!
Do not charge any batteries such as LiPo, Liion or LiFe with an end-of-charge voltage of 4.20V or less!
Do not change the battery type while charging is in progress!
• A lithium polymer (LiPo) battery pack should be put in a LiPo
charging bag or on a fire-resistant surface during charging.
• If your battery shows evidence of any abnormalities during the
charging process (overheating, hissing, swelling), remove the
battery from the charger immediately and place it away from
people and flammable materials.
• Never take the charger apart nor make any modifications to it.
• Never attempt to use the charger to charge or discharge
non-rechargeable batteries or damaged battery packs.
• Keep the charger away from children.
• Never leave the charger unattended when connected to the
power supply.
Charge status display
Battery Type
Status LED
Battery
Socket
"LiH" - LiHv Lithium High Voltage (Attention !! Only use for
appropriately marked rechargeable batteries)
Balance
socket
Current switch
2S 3S 4S
7 // GB