Pari TREK S Mode D'emploi page 17

Masquer les pouces Voir aussi pour TREK S:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Use the Battery Indicator lights to determine the status of the Battery: (Refer to Battery Illustration on
Page 3.)
Charging:
Charge LED "ON" - Battery is being charged.
Charge LED "OFF" - Battery is fully charged.
Operation With Battery:
Three Green Lights - Battery has more than 75% remaining battery life.
Two Green Lights - Battery has more than 50% remaining battery life.
One Green Light - Battery has more than 25% remaining battery life.
One Green Light flashing - Less than 25% of the battery life is remaining.
When the battery is completely discharged all indicators on the battery will extinguish and the compressor
will shut off. Refer to Charging the Battery on Page 18.
Note: If battery fails to operate, connect the Power Cord into the Multi-Voltage AC Adapter and plug the other end of
the Power Cord into the wall outlet. Plug the other end of the Multi-Voltage AC Adapter into the Charge Receptacle
on the side of the Rechargeable Battery. The Charge Indicator should turn "ON" indicating that the battery has re-set
and is now charging. If the Charge Indicator does not appear, or if all four indicators are blinking, the battery has
failed and should not be used. Please contact PARI Patient Connection at 1.800.FAST.NEB (327.8632) and
press 2.
5. To remove the Battery from the PARI TREK
(2-A) on the underside of the Rechargeable Battery then slide the Battery from the compressor (2-B) and
remove from the compressor. Refer to Page 4 Figure C, Numbers 2-A and 2-B.
6. The Rechargeable Battery can be recharged while it is attached to the PARI TREK
to Page 5 Figure F.
S Compressor, push and hold the Release Button down
®
15
S Compressor. Refer
®
ENGLISH

Publicité

Chapitres

Table des Matières
loading

Table des Matières