Operation From A Wall Power Source; Operation Using 12 Vdc Adapter; Operation Using The Rechargeable Battery - Pari TREK S Mode D'emploi

OPERATION FROM A WALL POWER SOURCE

1. Attach the Power Cord to the Multi-Voltage AC Adapter. Plug the other end of the Power Cord into the
wall outlet. The Power Indicator on Multi-Voltage AC Adapter will illuminate green. Next, plug the Multi-
Voltage AC Adapter into the Power Receptacle on the side of the PARI TREK S Compressor. Refer to Page
®
4 Figure A.
2. The PARI TREK S Multi-Voltage AC Adapter automatically adjusts to the incoming voltage (100-240 V)
®
so that it can be used in most countries. For use internationally, plug pattern adapters may be required to
plug the Power Cord into a wall outlet. See voltages listed on the Multi-Voltage AC Adapter label for more
specific information.
OPERATION USING 12V DC CAR ADAPTER
NOTE: Do not use the PARI TREK S Compressor or the PARI Reusable Nebulizer while operating a vehicle.
®
1. Plug the 12V DC Adapter into the vehicle outlet and plug the other end of the adapter into the Power
Receptacle on the side of the PARI TREK S Compressor or optional Rechargeable Battery Pack. Refer to
®
Page 4 Figure B.
OPERATION USING THE RECHARGEABLE BATTERY (optional accessory)
1. Completely charge the battery before using for the first time for more than two hours or until all three
battery level indicators are lit, and the charge indicator turns off. Refer to Charging the Battery on
Page 18.
2. The Rechargeable Battery can not be connected directly to the PARI TREK S Compressor if either the
®
Multi-Voltage AC Adapter or 12V DC Adapter are plugged into Power Receptacle of the PARI TREK S
®
Compressor. Refer to Page 4 Figure C Number 1.
3. Attach the Rechargeable Battery to the PARI TREK S Compressor by placing the Battery onto the rear
®
section of the PARI TREK S Compressor and sliding it into place. Refer to Page 4 Figure C Number 1.
®
Ensure battery is securely locked onto the compressor before use.
ENGLISH 14