Install The Cleaner; Submerge In The Pool - Aqua Products SSDP37 Serie Manuel De L'utilisateur

Install the Cleaner

CAUTION
To prevent damage to the cleaner, be sure
to adhere to the following guidelines:
Remove the cleaner from the pool after the
•
cleaning cycle is completed.
Store cleaner out of direct sunlight out of
•
direct sunlight or inclement weather.
Never lift the cleaner out of the pool by the
•
floating cable.
Take additional care when lifting the cleaner
•
out of the pool. It becomes heavier when
filled with water.
Always remove the cleaner from the pool
•
before super chlorinating or adding acid.
Do not handle cleaner while it is in operation.
•
IMPORTANT
Always make sure the cleaner head is fully
•
submerged before you begin operation.
Clean out debris after each cleaning cycle.
•
Do not leave your cleaner in the pool on a
•
permanent basis.
At the end of each cycle, remove the cleaner
•
from the pool.
Start at the cleaner head and untangle any
•
coils in the cable before storing the cleaner.

Submerge in the Pool

1. With the control box plugged into a
GFCI outlet, spread the floating cable
across the pool deck until you reach the
middle of the pool length.
NOTE: For optimal patterning and reduced tangling,
the floating cable should enter the water near
the middle of the pool length (Figure 3).
Midpoint of the Long side of Pool
12ft / 4m
Figure 3. Pool Entry Point for Optimal Patterning
2. Submerge cleaner vertically and turn
upside down until the bubbles stop to
remove any air trapped inside (Figure 4).
3. When the bubbles stop, allow the
cleaner to sink to the bottom of the
pool.
Figure 4. Submerge and Remove Trapped Air
4. Verify the cleaner is sitting right-side
up on the bottom of the pool. Remove
additional air if the cleaner is still
floating.
5. Spread all of the floating cable carefully
in the pool, ensuring there are no kinks
or coils. Use only as much cable as you
need to reach the farthest wall. This can
help prevent cable tangling (Figure 5).
7