Bimar HP118 Notice D'instructions page 13

• Do not hang or even lean the appliance against any walls.
• Place the fan heater far from any other source of heat, from flammable material (curtains,
tapestries, etc.), from flammable gases or explosive objects (spray cans) and from materials
that can be deformed by heat. Make sure there is 120 cm of free space in front of the fan
heater and 50cm free space on both sides and behind it.
• The surface where the appliance is used must be stable, spacious (do not use on shelves),
level (since the appliance could tip over) and heat resistant.
USING THE APPLIANCE
First use: run the appliance to eliminate the "new smell" and any oil residue from the
manufacturing process for at least 10/15 minutes. During this operation, ventilate the room
well to eliminate the "new smell" that is given off by the appliance.
The fan heater is equipped with the following adjustment devices:
To use the fan heater, please follow the instructions below:
1) Insert the plug in the current socket.
2) To turn on the appliance, turn the selector knob in the position corresponding at the
function requested.
0 Off
fan
fan + Right / Left automatic oscillation
Air warm (power 900W)
Air warm (power 900W) + Right / Left automatic oscillation
air very hot (power 1800W)
air very hot (power 1800W) + Right / Left automatic oscillation
3) Thermostat: regulates the appliance based on the surrounding ambient temperature: it
heats continuously until the set temperature is reached, and then it heats only when the
temperature decreases and for the period of time needed to bring it back up to the set
temperature. Use the respective knob: if turned fully in an anticlockwise direction, the
13