Pleasant Hearth 28-03-66 Mode D'emploi page 6

ASSEMBLY INSTRUCTIONS
5. Insert two dowels (DD) into predrilled holes on
bottom edge of lower front panel (E). Slip lower
front panel (E) behind upper front panel (E) so
that the dowels fit into predrilled holes as
illustrated. Insert four bolts (AA) through lock
washers (BB), flat washers (CC) and into
predrilled holes in the back side of upper front
panel (F) and assembled side panels. Tighten
with Phillips screwdriver (not included).
Hardware Used
AA
Bolt
Lock Washer
BB
CC
Flat Washer
DD
Dowel
6. Insert dowels (DD) into predrilled holes on
each end of top edge of assembly. Slip top
panel (A) over dowels (DD) so that the dowels
fit into predrilled holes in bottom edge. Insert
two bolts (AA) through lock washers (BB), flat
washers (CC) and into predrilled holes in top
panel (A). Tighten with Phillips screwdriver
(not included).
Hardware Used
AA
Bolt
Lock Washer
BB
CC
Flat Washer
DD
Dowel
5
E
x 4
x 4
x 4
x 2
6
x 6
x 6
x 6
x 4
6
DD
CC
F
CC
BB
AA
AA
BB
DD