Pleasant Hearth 28-03-66 Mode D'emploi page 4

ASSEMBLY INSTRUCTIONS
1. Insert dowels (DD) in predrilled holes on edge
of left pilaster (G). Slip left side panel (C) over
dowels (DD) so that the dowels fit into predrilled
holes in edge. Insert a bolt (AA) through a lock
washer (BB) and a flat washer (CC) and into
predrilled holes in top edge block of left side
panel (C) and top edge block of left pilaster (G).
Tighten with Phillips screwdriver (not included).
Repeat on center and lower edge blocks.
Hardware Used
AA Bolt
BB Lock Washer
CC
Flat Washer
DD
Dowel
2. Insert dowels (DD) in predrilled holes on edge
of right pilaster (H). Slip right side panel (D) over
dowels (DD) so that the dowels fit into predrilled
holes in edge. Insert a bolt (AA) through a lock
washer (BB) and a flat washer (CC) and into
predrilled holes in top edge block of right side
panel (D) and top edge block of right pilaster (H).
Tighten with Phillips screwdriver (not included).
Repeat on center and lower edge blocks.
Hardware Used
AA
Bolt
Lock Washer
BB
CC
Flat Washer
DD
Dowel
1
x 3
x 3
x 3
x 2
2
CC
BB
AA
x 3
x 3
x 3
x 2
4
DD
G
C
DD
D
CC
BB
AA
H