Télécharger Imprimer la page

Lorell LLR84162 Mode D'emploi page 2

Chaufferette numérique à chaleur rayonnante

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:
1.
Read all instructions before using this heater.
2.
This heater is hot when in use. To avoid burns, ensure that skin does not come into contact with hot surfaces.
Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet
(0.9 m) from the front of the heater and keep them away from the sides and rear.
3.
Extreme caution is necessary when any heater is used by or near children or elderly and whenever the heater
is left operating or unattended.
4.
Always unplug heater when not in use.
5.
Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or
damaged in any manner.
6.
Do not use outdoors.
7.
This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater
where it may fall into bathtub or other water container.
8.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord
away from traffic area and where it will not be tripped over.
9.
To disconnect heater, first turn controls to off, then remove plug from outlet.
10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric
shock or fire, or damage the heater.
11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like
a bed, where openings may become blocked.
12. Do not use it in the areas where gasoline, paint, or flammable liquids are used or stored.
13. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may
cause fire, electric shock, or injury to persons.
14. Always plug heater directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power
tap (outlet/power strip).
15. This heater draws 12.5 amps during operation. To prevent overloading a circuit, do not plug the heater into a
circuit that already has other appliances working.
16. It is normal for the plug to feel warm to the touch; however, a loose fit between the AC outlet (receptacle) and
plug may cause overheating and distortion of the plug. Contact a qualified electrician to replace loose or
worn outlet.
17. The output of this heater may vary and its temperature may become intense enough to burn exposed skin.
Use of this heater is not recommended for persons with reduced sensitivity to heat or an inability to react to
avoid burns.
READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
OPERATING INSTRUCTIONS
IMPORTANT!
Your heater is equipped with a polarized alternating current line plug
(a plug having one blade wider than the other). This plug will fit into the
power outlet only one way. This is a safety feature. If you are unable to
insert the plug fully into the outlet, try reversing the plug. If the plug still
fails to fit, contact your electrician to replace your outlet. DO NOT defeat
the safety purpose of the polarized plug.
CONTROL PANEL FUNCTIONS
A ON/OFF Button
B Mode Button
C LED Light
Place the heater on a firm level surface free from obstructions, and at least 3 feet away from any wall and
any other objects such as furniture, curtains, plants or combustible material.
With the ON/OFF BUTTON (A) in the "OFF" position, plug the heater into a grounded 120V outlet.
C.
2
B.
A.

Publicité

loading