Festo CPV-GEASI-4E3A-Z Serie Mode D'emploi page 23

3.6 Connection example – valve terminal type 10
1
AS-Interface master
2
Combination power-
supply from Festo
(electronically safe-
guarded/short-
circuit proof )
3
Load voltage can
be switched off
3.7 Converting the valve terminal
The CPV valve terminal can be fitted with double-solenoid
and/or single-solenoid valves. During conversion, the new
valve terminal configuration must be set on the DIP
switches on the bottom of the electric sub-base.
1
DIP switch on the
bottom of the sub-
base
Instructions on removign the electric sub-base can be
found in the Pneumatics Manual. The permitted valve
combinations as well as the relevant DIP switch settings
can be found in the table in section 3.3.
Festo CPV...-GE-ASI-4E3A-... 1108b English
1
2
3
1
23