Note About Switchable Retractors; Preparing For Use Initial Setup - hifold HF02C Serie Manuel

Vehicle Seat Belt Systems
Notes About Switchable Retractors
Many vehicles in Canada have a lap and shoulder
belt system in which the retractor can be switched
from the emergency locking mode (ELR) to an
automatic locking mode (ALR). The ALR mode is
not designed for use with booster car seats and
hifold is not recommended for use with a lap and
shoulder belt in the ALR mode.
Note: Should the lap and shoulder belt
inadvertently be switched into the automatic
locking retractor mode (ALR) and the vehicle seat
belt is locked, follow the steps below to remove the
lap belt.
1. Pull out and hold the shoulder belt to prevent
further retraction. Be aware not to allow shoulder
belt webbing to retract during this entire
procedure.
2. Have your child lean away from the vehicle
buckle.
3. Lift hifold up on the buckle side and remove lap
belt.
If the lap and shoulder belt is inadvertently switched
into the locking mode, see steps above and in
Removing Child section to remove child.
Preparing for Use
Initial Setup
In preparing the hifold for use with your child, you
will need to adjust the height and width of the hifold
to fit your child by following the steps in this section.
1
Unfold booster seat.
.
a. Unfold Headrest Sides -
Unbuckle Storage Straps.
Grasp both Headrest
Sides and rotate them
up into the open and
locked position.
CAUTION: Avoid pinch when
moving sides.
Keep fingers clear
of hinge.
9
EN