Publicité
Les langues disponibles
Les langues disponibles
MECHANICAL INSTALLATION
Mark the locations for the mounting screw holes by holding the AMPLIFIER
in place and using a scribe or one of the mounting screws, inserted in each
mounting hole in turn. To mark the mounting surface if carpeted, measure
the hole centres and mark with a felt-tip pen. Drill pilot holes for the
mounting screws into the holes of the system, insert the mounting screws
into the holes and tighten them securely.
CAUTION
Investigate the layout of your automobile thoroughly before drilling or
cutting any holes. Take care when you work near the gas tanks, lines, or
hydraulic lines, and electrical wiring. Don't use the power amplifier
unmounted. Attach this system securely to the automobile to prevent
damage, particularly in the event of an accident. Don't mount this system
so that the wire connections are unprotected or are subject to pinching or
damage from nearby objects.
The + 12VDC power wire must be fused at the battery positive terminal
connection. Before making or breaking power connections at the system
power terminals, disconnect the + 12V wire at the battery end. Confirm
your radio / cassette player and / or other equipment is turned off while
connecting the input jacks and speaker terminals.
If you need to replace the power fuse, replace it only with a fuse of diffe-
rent type or rating may result in damage to this system which isn't covered
by the warranty.
Page 16
© RTO 2000
Publicité
