Broan CBD1 Serie Mode D'emploi page 2

OPERATION
Always turn the hood ON before cooking in order to establish an
air flow in the kitchen. After turning off the range, let the hood run
for a few minutes to clear the air.
Operate the hood as follows:
FAN SWITCH
I
Turns fan on to LOW speed.
O
Turns fan OFF.
II
Turns fan on to HIGH speed.
Indicator glows blue when fan is on.
LIGHT SWITCH
I
Turns light on to LOW intensity.
O
Turns light OFF.
II
Turns light on to HIGH intensity.
CLEANING AND
MAINTENANCE
Proper maintenance of the Range Hood will assure proper
performance of the unit.
Motor
The motor is permanently lubricated and never needs oiling. If
the motor bearings make excessive or unusual noise, replace
the motor with the exact service motor. The impeller should also
be replaced.
Grease Filter
The grease filter should be cleaned frequently. Use a warm
dishwashing detergent solution. Grease filter is dishwasher safe.
Clean all-metal filters in the dishwasher using a non-phosphate
detergent. Discoloration of the filter may occur if using phosphate
detergents, or as a result of local water conditions - but this will
not affect filter performance. This discoloration is not covered by
the warranty.
See "INSTALL FILTERS" section for removal and installation
instructions.
Non-ducted Recirculation Filter
The non-ducted recirculation filter should be changed every 6
months. Replace more often if your cooking style generates extra
grease, such as frying and wok cooking. See Step 24, for removal
and installation instructions.
Stainless Steel Cleaning
DO:
• Regularly wash with clean cloth or rag soaked with warm water
and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning.
Wipe dry completely.
• You may also use a specialized household stainless steel cleaner.
DON'T:
• Use any steel or stainless steel wool or any other scrapers to
remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the
hood. During construction/renovation, cover the range hood to
make sure no dust sticks to the stainless steel surface.
Avoid: When choosing a detergent
• Any cleaners that contain bleach will attack stainless steel.
• Any products containing chloride, fluoride, iodide, bromide
will deteriorate surfaces rapidly.
• Any combustible products used for cleaning, such as
acetone, alcohol, ether, benzol, etc. are highly explosive and
should never be used close to a range.
LIGHT BULB REPLACEMENT
HALOGEN
BULB
(2)
ROTATE
CLOCKWISE
CAUTION: Bulbs may be hot. Refer to bulb
packaging for further information.
Use 120 V, 35 W, Halogen Bulbs - MR16 with GU10 base.
The Suction Cup Tool (included with hood) can be used to install
and remove light bulbs. Press suction cup tool on to bulb and
rotate counterclockwise to remove bulb or clockwise to install bulb.
Align pins on bulb with large diameter opening on socket, then
push bulb in towards hood and rotate clockwise until firmly seated.
The position of the bulb socket (depth) is adjustable and may
require adjustment when:
a) certain brands of bulbs are difficult to install.
b) the bulb protrudes too far below the light panel.
See Step 23 for bracket adjustment detail.
CBD1 SERIES
Page 2
SUCTION
CUP TOOL
(1)
PUSH IN
LIGHT PANEL