Publicité
Les langues disponibles
Les langues disponibles
21
BIP500 BUILT-IN INSTRUCTIONS
(Pre-installed at factory.)
3/8"(10mm)
2 x N570-0086 (#14 X1/2")
4 x N570-0087 (1/4 -20 X 7/8")
This grill is designed for masonry, NON-COMBUSTIBLE enclosures only, and must be installed and serviced by a qualified
installer to local codes.
1. Attach the side mounting brackets to each side of the grill using (4) 1/4 - 20 x 7/8" screws (N570-0087).
2. Attach the rotisserie mount bracket to the side of the grill using (2) #14 x 1/2" screws (N570-0086).
3. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied to each wing of
the rear trim.
4. Lower the unit in place, the wings on the rear trim should be under the side mounting brackets. Connect the flex supply line
to the fitting at the end of the manifold.
5. The entire installation must be leak tested before operating the unit.
www.napoleongrills.com
Publicité
