Connecting A Vacuum Cleaner; Hex Wrench Storage - Makita SH02 Manuel D'instructions

1
2
3
1. Hex bolt 2. Protrusion
flange 4. Circular saw blade
6. Protrusion (bigger side)
NOTE: If a inner flange is removed by chance, install
the inner flange so that its protrusion (bigger side)
faces inside as shown in the figure.
When changing the circular saw blade, make sure to
also clean the upper and lower blade guards of accu-
mulated sawdust as discussed in the Maintenance
section. Such efforts do not replace the need to check
lower guard operation before each use.

Hex wrench storage

1. Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
5
6
4
3. Outer
5. Inner flange
1

Connecting a vacuum cleaner

Optional accessory
2
1. Dust nozzle (optional accessory)
(optional accessory)
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner to your tool. Install
the dust nozzle (optional accessory) on the tool using
the screw. Then connect a hose of the vacuum cleaner
to the dust nozzle as shown in the figure.
OPERATION
CAUTION:
Be sure to move the tool forward
in a straight line gently. Forcing or twisting the tool
will result in overheating the motor and dangerous
kickback, possibly causing severe injury.
1
2. Screw
ENGLISH 9