Recharging With Solar Panels (Optional) - Westinghouse iGen600s Mode D'emploi

RECHARGING WITH SOLAR PANELS (OPTIONAL)

Make sure to use panel with 8mm output plug� Place solar panel where
it will get as much direct sunlight as possible� Plug the output of the solar
panel into the input on the back of the power station to start charging�
You will know the unit is charging when the red LED battery indicator
light is on� The unit is fully charged when all battery indicators on the
LED display are illuminated�
NOTICE: When solar recharging your power station, take note of the
voltages of the solar panels and do not exceed 19V� Individual solar
panels, or solar panels chained in series in excess of 19V cannot be
used with the power station and can cause serious damage to the unit�
For help on chaining solar panels, call our Customer Service Center at
1-855-944-3571�
COLD WEATHER USE
Cold temperatures (below freezing) can affect the unit's battery capacity
due to chemical characteristics of the battery� If you'll be living off-grid in
sub-zero conditions, we recommend you keep your unit in an insulated
cooler, and connected to a power source (solar panels)� The natural
heat generated by the unit contained in an insulated cooler will keep
battery capacity at its highest�
Westinghouse Outdoor Power Equipment - 15