Bpt IT/200 Instructions page 41

Self-connection on entry panel
The entry panel can be activated for any of
the following needs:
• audio and video monitoring of the entran-
ce (where the entry panel features a
camera);
• exchanging entry panels;
• releasing door lock.
NOTE. Self-connection is only possible
when the set is combined with the video
module XV/200 and when the video entry
system is not engaged.
Interlocutor switching
This function enables the user, whilst com-
municating with an outside line or the entry
panel, to answer a call on the other line,
putting the current conversation on hold.
The interlocutor put on hold hears a tone
advising him/her of the current hold status.
NOTE. During the conversation, a sound
advise the user of the incoming call.
In order to switch between interlocutors
during a conversation:
Press
telephone transfer key (in the
case of bpt telephones; for
other telephones, consult the
summary table).
NOTE. If the interface is programmed with
the FLASH INTERCEPTION function disa-
bled, the control will not work using a stan-
dard multifrequency set whilst communica-
ting on the local telephone line.
FUNCTIONS
the entry handset/
Porter call
Lift the receiver
or
press the hands-free key.
Wait for the dial tone.
Press the porter call key (in the
case of bpt telephones; for
other telephones, consult the
summary table).
Once the conversation is over,
replace the receiver
or
press the hands-free key.
NOTE. If the interface is programmed with
the FLASH INTERCEPTION function disa-
bled, the control will not work using a stan-
dard multifrequency set whilst communica-
ting on the local telephone line.
39