Setup
Part names and
functions
Front cover
Mounting adaptor release lever
Mounting adaptor
M
Used to confirm the status of the
sensor or register the sensor to
the hub.
LED indicator
8
HNS107C_(en_en)_0212_ver.011.pdf
A
B
D
E
N
For assistance, visit www.panasonic.ca/english/support
8
LED indicator
You can press M
LED indicator to confirm the sensor's
status. After confirming the sensor's
status, we recommend turning the LED
indicator off by pressing M
as soon as possible, otherwise battery
life may be reduced.
Indicator
Green, lit
Red, lit
Red,
blinking
C
Green,
blinking
slowly
Off
Note:
R The LED indicator does not indicate
sensor status if the sensor has not
been registered (page 10).
N and check the
N again
Status
Door is closed
Door is open
Sensor is out of range
of the hub
Registration mode
(You pressed and held
M
N)
No battery power
2016/02/12
9:35:26