Setup
Replacing the battery
Use this procedure when replacing the
battery after installation.
1
Remove the sensor from the
mounting adaptor by pressing the
release lever, sliding the sensor up
and lifting it away from the
mounting adaptor.
2
Remove the front cover.
3
Replace the battery with a new
one.
4
Attach the front cover.
5
Attach the sensor to the mounting
adaptor.
R The sensor will click into place
R Make sure the "UP" marks on
Registering the
sensor
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the sensor, it must
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
10
HNS107C_(en_en)_0212_ver.011.pdf
when it is secured.
the back of the sensor and the
inside of the mounting adaptor
point in the same direction.
For assistance, visit www.panasonic.ca/english/support
10
Using registration buttons
1
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks slowly in green.
2
Sensor:
Remove the front cover, and then
press and hold M
LED indicator blinks slowly in
green (page 8).
R When registration is complete,
the hub sounds one long beep.
Note:
R To cancel without registering the
sensor, press M
N on the hub and
on the sensor again.
R If registration fails, the hub sounds
several short beeps.
Using the app
When you register the sensor by using
the [Home Network] app, you can
assign it a name and location. For
more information, refer to the User's
Guide (page 16).
OTHER
N until the
2016/02/12
9:35:26