Mounting The Sensor - Panasonic KX-HNS107C Mode D'emploi

Mounting the sensor

In most cases, you can mount the
sensor to the garage door using
double-sided tape. In some cases,
such as when mounting the sensor to a
wooden surface, you can use screws.
Installation precautions
R Observe the following to avoid the
risk of falling, which could cause
injury or damage to property.
– Mount the sensor on a stable
– Do not mount the sensor on
R Install the sensor on the inside of the
garage door.
R Mount the sensor near the top of the
garage door. Additionally, we
recommend mounting the sensor
near the left or right edge of the
garage door, so that the sensor is
not directly above the car when the
garage door is open.
For assistance, visit www.panasonic.ca/english/support
HNS107C_(en_en)_0212_ver.011.pdf
surface where the sensor will be
adequately supported.
plywood less than 25.4 mm
(1 inch) thick.
13
Securing with double-sided
tape
Important:
R Make sure the surfaces of the
mounting adaptor and the
installation area of the garage door
are clean and dry before applying
double-sided tape. Take particular
care to remove any oil or grime that
has accumulated on the garage
door.
R Install the sensor on a smooth area
of the garage door. Ideally there
should be no pits or grooves deeper
than 0.5 mm (0.02 inches).
R Once you have used the
double-sided tape, do not reuse it.
R When mounting the sensor in cold
temperatures, observe the following
to ensure optimal adhesion.
– Affix the double-sided tape to the
mounting adaptor indoors, when
the tape and the adaptor are at
room temperature.
– Use a hair dryer or other low-heat
emitting device to warm the
installation surface of the garage
door immediately prior to
adhesion, otherwise adhesion
may be poor and the sensor may
fall.
Setup
13
2016/02/12 9:35:26