Videotec ODBH18K1 Manuel D'instructions page 5

6 Installing and assembling
Only specialised personnel should be
h
allowed to install and assemble the device.
Take care when working with the
l
heater PTC, the element can reach
very high temperatures.
6.1 Installation
Fig. 1
Fit the dissipator using two supplied M3x8mm screws,
positioning it under the fan housing. The screws
should pass through the eyelets on the adapter ring.
Then attach the fan to its housing using
the supplied M3x25mm screws.
Fig. 2
Attach the PTC heater to the outside of
the dissipator using the supplied clip.
Fig. 3
Wire up the PTC by inserting the connector into
the corresponding socket on the HEAT board.
Use the straps to secure the cable to the
ring and so that it does not get in the way
of the camera and related adapter.
MNVKDBH18H_0804_EN • 3