Publicité
Les langues disponibles
Les langues disponibles
4
Identification
4.1
Product description
and type designation
Upgraded heater for low-temperature use.
Easy to install inside the MEDUSA - DBH18
dome enclosure it is able to distribute heat
more uniformly inside the housing.
Available in 2 types:
ODBH18K1
•
- 115/230Vac version.
ODBH18K2
•
- 24Vac version.
4.2
Product markings
See the label attached to the outside of the package.
5
Preparing the
product for use
Any change that is not expressly
h
approved by the manufacturer
will invalidate the guarantee.
2 • MNVKDBH18H_0804_EN
5.1
Safety precautions
before use
Before carrying out any technical work,
l
disconnect the power supply and
then wait at least 30 minutes to allow
the heating system to cool down.
The kit has been designed specifically as
g
an accessory for the MEDUSA - DBH18
dome enclosure; do not change the wiring
already done by the manufacturer.
5.2
Contents and unpacking
When the product is delivered, make sure that
the package is intact and that there are no
signs that it has been dropped or scratched.
If there are obvious signs of damage,
contact the supplier immediately.
Keep the packaging in case you need
to send the product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
•
2 pre-wired PTC
•
2 blowers
•
2 dissipator
•
2 blocking springs for PTC
•
4 M3x25mm self-tapping screws
•
4 M3x8mm self-tapping screws
•
4 clamps
5.3
Safely disposing of
packaging material
The packaging material can all be recycled.
The installer technician will be responsible for
separating the material for disposal, and in
any case for compliance with the legislation
in force where the device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging
for its transport is strongly recommended.
Publicité
