Cleaning And Storage - Andrews Sykes Polar Wind PLUS Manuel D'instructions

6. On-Timer Operation
- When the air-conditioner is OFF, press the "Timer" button and select (with the "Temp+"and
"Temp-" buttons) a time after which the air conditioner will turn ON.
- The time period can be set in 1-hour increments (up to 24 hours) and is shown in the LED
Display
7. Off-Timer Operation
- When the air-conditioner is ON, press the"Timer"button and select (with the"Temp+"a
"Temp-" buttons) a time after which the air conditioner will turn OFF.
- The time period can be set in 1-hour increments (up to 24 hours) and is shown in the LED
Display.
8. Draining the Water Tank
This Air Conditioner has an internal water tank that collects water that condenses inside the
unit during normal operation. When this water tank fills with water, the 'Water Full'
Indicator on the Control Panel will blink.
The water tank can be emptied in one of two ways:
Auto pump w ater function of w ater pump
When the unit has cooling functions, and the units has used the water pump. Under random
mode, If the water level in the water tank is higher than the below picture water level, water
level switch will close, and the water pump indicator will light up. The water pump will
work to drain the water through drain pipe.
Manual Drainage - Continuous
To do this, one end of the drain pipe must be connected to the Water Drain Outlet during
use, and the other end leading to a water drain or similar. No section of the drain pipe
must be raised for this drainage method to work.
Note: continuous drainage may affect the air conditioner's efficiency,and so manual
drainage is preferable for normal use.
Important:
· Before cleaning, be sure to unplug the unit from the power .
· Before storage, it is important to drain the water from the water tank completely (see
'Operation' section).
1. Cleaning the Air Filter
If the air filter becomes clogged with dust/dirt, the air filter should be cleaned. Cleaning the
filters once every two weeks of use is recommended.
- Dismounting
Open the air inlet grille and take off air filter.
Clean the air filter with neutral detergent in lukewarm water (<40°C) then dry in the shade.
-
Mounting
Putting the air filter into the inlet grille; replace the components as they were.
- -

Cleaning and Storage

8