Hitachi RPIL-1.5FSRE Manuel D'installation Et De Fonctionnement page 34

INDOOR UNITS INSTALLATION
4 INDOOR UNITS INSTALLATION
4.1 TRANSPORTATION AND HANDLING
!
C A U T I O N
• Do not put any material on the product.
• Do not step on the product.
4.1.1 Transportation of indoor unit
• Transport the product as close to the installation location as
possible before unpacking.
• Do not put any material on the indoor unit.
• The indoor unit is packed upside down and therefore the
foamed polyethylene drain pan is exposed at the upper side.
Do NOT put the indoor unit with the drain pan side down
during the process from unpacking the indoor unit to hanging
up the unit to a ceiling. In addition, do NOT handle the indoor
unit by the drain pan portion or the air outlet portions.
• It is necessary to turn it between two technicians.
4.2 FACTORY SUPPLIED COMPONENTS
Check to ensure that the following accessories are packed with the indoor unit.
Washer with insulation material (M10)
Washer (M10)
Drain hose
Hose clamp
Drain hose gravity kit
Plastic ties
Insulation (5Tx100x200)
Pipe insulation (Ø28x125)
Pipe insulation (Ø43x125)
Plastic ties
?
N O T E
• If any of these accessories are not packed with the unit, please contact your contractor.
• The air panel, remote control switch and branch pipes are optional accessories and so are not included.
4 PMML0527 rev.1 - 02/2021
Accessory
Accessory
Checking Scale
Checking Scale Accessory
(Cut and Take Out it
(Cut and Take Out it
from the Carton Board) Checking Scale
from the Carton Board) Accessory
(Cut and Take Out it
Accessory
Checking Scale
from the Carton Board)
Cross Recessed
Cross Recessed
Checking Scale (Cut and Take Out it
Accessory
Head Screws (M5)
Head Screws (M5)
(Cut and Take Out it from the Carton Board)
Cross Recessed
from the Carton Board)
Washer with Insulation Head Screws (M5)
Cross Recessed
Material (M10)
Washer with Insulation
Cross Recessed Head Screws (M5)
Material (M10) Head Screws (M5)
Washer with Insulation
Washer (M10) Material (M10)
Washer with Insulation
Washer with Insulation Material (M10)
Washer (M10) Material (M10)
Washer (M10)
Drain Hose
Washer (M10)
Washer (M10)
Drain Hose
Hose Clamp
Drain Hose
Drain Hose
Drain Hose
Pipe Insulation
Hose Clamp Hose Clamp
Hose Clamp
Hose Clamp
Pipe Insulation
Pipe Insulation Pipe Insulation
Pipe Insulation
Pipe Insulation
Cord Clamp
Pipe Insulation
Pipe Insulation
Pipe Insulation
Pipe Insulation
Cord Clamp
Cord Clamp
Cord Clamp
Cord Clamp
Insulation
Cord Clamp
(5Tx50x200)
Cord Clamp
Cord Clamp Cord Clamp
Insulation
Cord Clamp Insulation
(5Tx100x200)
Insulation (5Tx50x200)
Insulation
(5Tx50x200)
(5Tx50x200)
Insulation
(5Tx25x500)
Insulation Insulation
Insulation (5Tx100x200)
(5Tx50x200)
Insulation
(5Tx100x200)
(5Tx100x200)
Insulation
Insulation
Insulation (5Tx25x500)
Insulation
(5Tx25x500)
(5Tx100x200)
(5Tx25x500)
Insulation
(5Tx25x500)
4.1.2 Handling Of Indoor Unit
!
D A N G E R
Do not put any foreign material into the indoor unit and check to
ensure that no foreign material exists in the indoor unit before
installation and the test run. Otherwise, a fire or failure, etc. may
occur.
?
N O T E
When lifting or moving the indoor unit, use appropriate slings to avoid
damage and be careful not to damage the insulation material on units
surface.
Purpose
Q'ty
Q'ty Purpose
For Adjusting Space of False
For Adjusting Space of False Purpose
Q'ty
Ceiling Opening and
1
Ceiling Opening and
1
For Adjusting Space of False Position of the Unit
Position of the Unit Purpose
Q'ty
Ceiling Opening and
Q'ty 1 Purpose
For Adjusting Space of False
Position of the Unit
4 For Fitting Paper Pattern
For Adjusting Space of False Ceiling Opening and
1 Qty.
4 For Fitting Paper Pattern
Ceiling Opening and Position of the Unit
1
Position of the Unit
4 For Fitting Paper Pattern
4
4 For Fitting Paper Pattern
4
4
4 For Fitting Paper Pattern
For Unit Installation
4
For unit installation
4
For Unit Installation
4
For Unit Installation
4
4
For Unit Installation
4
4
For Unit Installation
1
4
4
For Drain Hose Connection
1
1 1
1
1
For Drain Hose Connection
1
For Drain Hose Connection
For Drain Hose Connection
For drain hose connection (drain pump)
For Drain Hose Connection
1
1 1
1
2
For Refrigerant Piping
1
Connection
1
1 1
1
1
For Refrigerant Piping
For Refrigerant Piping
For Refrigerant Piping
For Refrigerant Piping Connection
Connection 1
2
For Fixing Remote Control
1 Connection
Connection
1
Switch Wiring, Louver Sensor
1
1 For drain hose connection (gravity drain)
and Insulation of Piping
6
2
For Fixing Remote Control
2
2 2
For Fixing Remote Control
For Fixing Remote Control Switch Wiring, Louver Sensor
For Covering Wiring
2
Switch Wiring, Louver Sensor
1
Switch Wiring, Louver Sensor and Insulation of Piping
For Fixing Remote Control
Connection
6
and Insulation of Piping
and Insulation of Piping
Switch Wiring, Louver Sensor
6 6
For covering drain connection
and Insulation of Piping 1
For Covering Drain
1
6 For Covering Wiring
Connection
1
For Covering Wiring Connection
For Covering Wiring
1
1
Connection
Connection
For Covering Drain
1
1
Connection
For Covering Drain For Covering Wiring
1
1
For Covering Drain Connection
Connection
1 For Covering Drain
Connection
1
Connection
For Covering Drain
1
For Covering Drain 1
Connection For Covering Drain
For covering gas/liquid pipe
1
1 For Covering Drain
Connection
1 Connection
Connection
For Covering Drain
1 4
Connection
Purpose