Operating Instructions & Parts Manual
Description
The submersible pump is designed
for indoor home sump applications.
The unit is equipped with an 8-ft
long, 3-prong grounding type power
cord. Motor is oil filled and sealed
for cooler running and designed to
operate under water. A float switch
or solid-state electronic water level
control is provided for automatic pump
operation. This pump is not suitable for
aquatic life.
Unpacking
After unpacking the unit, inspect
carefully for any damage that may
have occurred during transit. Make sure
to tighten fittings, bolts, etc., before
putting unit into service.
Safety Guidelines
This manual contains information
that is very important to know and
understand. This information is
provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help
recognize this information, observe the
following symbols.
Danger indicates an
imminently
hazardous situation which, if not
avoided, WILL result in death or serious
injury.
Warning indicates a
potentially
hazardous situation which, if not
avoided, COULD result in death or
serious injury.
Caution indicates a
potentially
hazardous situation which, if not
© 2008 Blue Angel™ Pumps
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or
maintain the product described. Protect yourself and others by observing all safety information. Failure to
comply with instructions could result in personal injury and/or property damage! Retain instructions for future
reference.
Submersible
Sump Pump
avoided, MAY result in minor or
moderate injury.
information, that if not followed, may
cause damage to equipment.
IMPORTANT: Information that requires
special attention.
General Safety Information
CALIFORNIA PROPOSITION 65
contain chemicals known to the State
of California to cause cancer and birth
defects or other reproductive harm.
Wash hands after handling.
GENERAL SAFETY
Read these rules and
instructions carefully. Failure
to follow these instuctions
could cause serious bodily
injury and/or property
damage.
pump fl ammable or explosive
fl uids such as gasoline, fuel
oil, kerosene, etc. Do not
use in a fl ammable and/or explosive
atmosphere. Pump should only be used
to pump clear water. Personal injury
and/or property damage could result
to handle salt water, brine, laundry
discharge or any other application
which may contain caustic chemicals
and/or foreign materials. Pump damage
could occur if used in these application
and will void warranty.
REMINDER: Keep your dated proof of purchase for warranty purposes!
Attach it to this manual or file it for safekeeping.
For parts, product & service information
visit www.blueangelpumps.com
BWST, BWSF and BWSCAP Series
qualifi ed electrician. Failure to follow
Notice indicates
this warning could result in fatal
important
electrical shock.
has water or moisture on
the fl oor, do not walk on
wet area until all power is
turned off. If the shutoff box is in the
basement, call an electrician. Remove
pump and either repair or replace.
Failure to follow this warning could
This product or
result in fatal electrical shock.
its power cord may
Angel offers Model BSP15 and BSP25.
Assembly
VERTICAL FLOAT SWITCH (BWSF
ONLY)
MANUAL
Place the float bracket onto the handle
of the motor housing and slide the
switch assembly securely into place.
Do not
use to
This pump is
not designed
Figure 1
All wiring must be
performed by a
If the
basement
A backup system
should be used. Blue
Switch housing
Float
bracket
Float
350704-002 9/08