Ugolini NG6 Easy Carnet D'instructions page 23

10 ROUTINE MAINTENANCE
1 Every day: inspect the dispenser and check for leaks of
product from the gaskets. If you notice leaks, first make sure
that the components of the dispenser are properly installed,
then check that the gaskets do not require lubrication and
finally that they are not worn or damaged. If they are, replace
them with original spare parts from the manufacturer.
2 Every month: remove the dust from the condenser filter on
the back of the machine (see figure 24).
figure 24
ATTENTION
Beware of the condenser fins as they are sharp.
3 In case of noise it needs to unplug the cooler and call for
service.
4 In case of failure unplug the machine, because unexpected
start again would be possible.
5 It needs to fix everything back in the initial position after any
repairmen, like screws and covers.
IMPORTANT
"soft drink mode" is not to be used in lieu of proper clea-
ning and sanitization procedures at the frequencies
required by the federal, state, or local regulatory agency.
10. 1 MAINTENANCE (TO BE CARRIED OUT
BY QUALIFIED SERVICE PERSONNEL
ONLY)
IMPORTANT
In order to prevent damage to the dispenser, the plastic
parts must only be lubricated with the grease supplied by
the manufacturer or with another type of grease compati-
ble with plastic parts.
Annually: Remove all the panels and clean the inside of the
machine including the base and the inside of the panels.
Never remove the anti-condensation material wrapped around
the evaporator outlet tube (the copper tube located to the right
of the geared motor). If said material is missing or lost, replace
with original spare parts from the manufacturer.
23