Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
StormPro
Battery Back-Up Power Supply
General Information
Thank you for purchasing your StormPro product.
To help insure years of trouble free operation,
please read the following manual carefully.
Before Operation
Reasonable care and safe methods should be
practiced. Check local codes and requirements
before installation. This manual contains
important information for the safe use of this product.
Read this manual completely before using
this product and refer to it often for continued safe
product use. DO NOT THROW AWAY OR
LOSE THIS MANUAL. Keep it in a safe place so
that you may refer to it when needed.
Warning
Always disconnect the Unit from the receptacle
power source and battery before handling or
making any adjustments to the system.
Battery Backup Warning:
1. Risk of electrical shock this Unit has not been
investigated for use in outdoor areas.
2. Risk of electrical shock connect only to a
properly grounded, three pronged grounding
type receptacle. Under any circumstances
do not remove the grounding prong from the
power cord.
3. Do not smoke, use sparkable electrical
devices or open flame when working on this
Unit!
4. Do not install Unit in locations classified as
hazardous per N.E.C., ANSI/NFPA 70 - 1999.
FAILURE TO HEED ABOVE CAUTIONS
COULD RESULT IN INJURY OR DEATH.
Register your product at
www.sumpro.com
OPERATION MANUAL
Dated: 12/12/08
Supersedes: None
Document No.: SP-OM
ATTENTION:
The StormPro Back Up System is only to be used
with the StormPro Pump supplied with the Unit.
Using anything other than the Pump supplied with
the system will cause damage to the Unit and void
the warranty.
TOOLS NEEDED:
A pipe wrench, pliers, adjustable wrench, and
screwdriver will be needed.
BATTERY REQUIREMENTS:
Your Unit operates on 12VDC battery power when
in the power fail mode, a UL. recognized deep cycle
marine battery should be used.
We recommend:
Metropolitan Industries
Power + Battery
Model# 27-AGM
Factory Tel: 800-323-1665
Installation Instructions
1. Open the lid on the battery enclosure and place
the lower half of the battery enclosure with the
Unit in a suitable place were a 120V three prong
outlet is within reach of the receptacle power
cord, and were water will not drip or splash on
the Unit. It is also important to make sure that
the fan inlets on each side of the battery back-
up enclosure are free from obstructions. It is
also recommended that the Unit be placed on
a board or cinder block to keep it off the moist
floor and free from debris.
2. After the battery box has been put in a suitable
location the battery can be installed.
BATTERY INSTALLATION
A battery can present a risk of severe burns and
injury from high short circuit current. The following
precautions should be observed when working on
batteries.
1. Remove watches, rings, or other metal
objects.
2.
Use tools with insulated handles.
3.
Do not lay tools or metal parts on top of
batteries.
Metropolitan Industries, Inc.
www.metropolitanind.com
Page 1 of 11
Publicité
Sommaire des Matières pour Metropolitan Industries StormPro
- Page 1 Document No.: SP-OM Page 1 of 11 ATTENTION: The StormPro Back Up System is only to be used with the StormPro Pump supplied with the Unit. Using anything other than the Pump supplied with the system will cause damage to the Unit and void the warranty.
- Page 2 5 amps. terminal. Make sure all battery connections are Only use a Stormpro 1/3HP pump Model # BA- properly tightened to 75 inch pounds. Then place 33V with the StormPro power supply.
- Page 3 DC Note: The StormPro backup system and existing power by activating the switch. Be sure to plug primary pump must be plugged into separate the power unit plug back into the wall outlet.
- Page 4 Spilled electrolyte should be washed down with a suitable acid neutralizing agent. A common practice 9. The StormPro Back-Up System is used with is to use a solution of approximately one pound any other pump than the StormPro BA-33V (500 grams) bicarbonate of soda to approximately 1/3hp pump.
- Page 5 Page 5 of 11 Warranty Coverage and Term. Metropolitan Industries, Inc. (“Metropolitan”) warrants to the original purchaser (the “Buyer”) of each Metropolitan product (the “product”), that any part thereof which proves to be defective in material or workmanship within one (1) year from date of installation or 18 months from the date of manufacture, whichever comes first, will be replaced at no charge with a new or remanufactured part, F.O.B.
- Page 6 StormPro OPERATION MANUAL Dated: 12/12/08 Battery Back-Up Power Supply Supersedes: None Document No.: SP-OM Page 6 of 11 FRENCH VERSION Metropolitan Industries, Inc. Register your product at www.sumpro.com www.metropolitanind.com...
- Page 7 DOMMAGES OU LA MORT. ATTENTION: 2. Utilisez les outils avec les poignées isolées. Le système de secours de StormPro doit être employé seulement avec la pompe de StormPro 3. N’étendez pas les outils ou les pièces en métal fournie avec l’unité. Utilisant n’importe quoi autre que sur des batteries.
- Page 8 5 ampères. Employez seulement un modèle la vers le bas de sorte que les enfants ne puissent de pompe de Stormpro 1/3HP # BA-33V avec pas trifouiller l’unité. Actuellement vous peut l’alimentation d’énergie de StormPro.
- Page 9 Diagramme d’installation actionnant le commutateur, débranchent alors l’alimentation d’énergie de la sortie électrique Note : Le réseau de réserve de StormPro et la et examinent la pompe sur l’alimentation CC pompe primaire existante doivent être branchés En actionnant le commutateur. Soyez sûr aux sorties consacrées séparées...
- Page 10 8. L’unité a été appliquée à la tension fausse. éclat complètement et immédiatement avec de l’eau. Attention médicale de recherche. 9. Le système de secours de StormPro est em- ployé avec n’importe quelle autre pompe que la d. L’électrolyte renversé devrait être lavé vers le pompe de StormPro BA-33V 1/3hp.
- Page 11 Page 11 of 11 Garantie 1. Assurance et limite. Garanties de Metropolitan Industries, Inc. (la « métropolitaine “) à l’acheteur original (« l’acheteur “) de chaque produit métropolitain (le « produit “), que n’importe quelle partie en qui s’avère défectueuse dans le matériel ou l’exécution dans un délai d’un (1) an de date d’installation ou de 18 mois de la date de la...