Trevi 222 Instructions D'assemblage page 9

25x38-Trevi 222 RONDE_25x38-Trevi 209 RONDE.qxd 2010-03-01 14:41 Page 9
9
1
Illustration 11.1
11
Place the top seat on the upper side of the upright, and
secure with two (2) pan head decorative screws.
12
Position the safety procedures panel on the outside of the
pool. This panel must be at the most visible place from the
yard on your pool.
13
Note: See 'Safety Information" Manual, Page 1.
As described in the manual, all components of the
filtration system should be placed to prevent a child to
climb on top and get access to the pool.
Using a little bit of stone dust (or sand), place at level a
patio stone 61cm x 76 cm (24" x 30") before installing the
motor and filter.
Position the motor on the stone and insert the two nozzles
to connect the hoses.
Then, install the filter tank. Adjust the lateral assembly
properly in its channel. It is sometimes necessary to
install the laterals.
Patch the center hole of the lateral assembly using the
plug to allow filtering sand to flow into the tank.
Remove the plug. Install the joint in the cavity and secure
the filter head by placing the back wash position on
opposite side of the pool.
Install necessary nozzles, then connect hoses using
collars.
1. The first hose runs from the top of the pump to the side
of the filter head;
2. The second one goes from the pump to the skimmer
(or to the bottom drain valve);
3. The third goes from the front of the filter head to the
water return or from the front of the chlorinator to the
water return.
A back wash hose may be placed behind the filter head.
If there is a chlorinator and/or heat pump, it must be
assembled at the filter exit.
All manuals and user guides at all-guides.com
uPright iNstallatioN
back cover iNstallatioN
toP seat iNstallatioN
securitY sigNs iNstallatioN
filtratioN sYstem assemblY
Clip the uprights to the bottom joiner plates.
Make sure the post is well snaped into the bottom plate
Clip the upright back cap into the upright
(see illustration 11.1).
Make sure the upright back cap is well snaped into the
post.
Place the three (3) safety stickers inside the pool in a way
that it's seen from any entry point of the swimmer (See
positionning drawing).