HITEC Multichargers X4 MICRO SE Mode D'emploi page 3

Introduction
Thank you for your choice of the HiTEC multicharger X4 MICRO SE. This unit is simple to use but it´s
operation does require some knowledge on the part of the user. Please read this entire operating manual
completely and attentively before using this product, as it covers a wide range of information on operating
and safety.
The multicharger X4 MICRO SE employs the circuit that features four totally independent but identical power
outputs which are powered 5W each. It is designed for charging single cell LiPo. Insert the battery lead to
the right connector in each port, the charger will charge 4 batteries at the same time. And the charging
current can be adjusted from 0.05 to 1.2A by dial, the charging capacity and cell voltage can be displayed in
the digital LED indicator.
JST
Micro
MX
4-Digital LED
Indicator
Charging Status
LED Indicator
AC Input Power Port
100-240V
Specifikation
AC / DC Input 100-240V / 11-15V
Charge circuit power 4x 5,22W ± 10%
Charge current range 0.05 - 1.2A ± 10%
Battery type 4x 1 Zelle LiPo / LiHV
Battery connector type Micro / JST / MX / mCPX
Working temperature 0-50°C
Net weight 245 g
Dimension 130x94x50mm
# 1-00689
Instruction manual
EN
DC Input
mCPX
Power Jack
11-15V
Rotary Dial
for Setting
Charging Current
Start/Stop Button
Errors and omissions excepted © MULTIPLEX
Features
· Four independent ports can be used at the same time
· Four different kinds of battery connectors at each port
· Four independent functioning charging circuits
· Four independent digital LED Displays
· LED and audible sound indicate charging status
· Adjustable charging current from 0.05 to 1.2A
· AC/DC Dual Power Input
· Maximum protection: short circuit protection; over current protection; battery reverse polarity protection
and DC input voltage protection
Charging
When using AC power source
1. Insert the AC power cord into the charger.
2. Insert the AC power cord into a wall socket (100-240V).
3. When charger is powered on, 4 status LEDs will blink
once with one beep and all digital LED indicators will
display 8888. After that, 4 LEDs will extinguish and all
digital Displays will show the charging current which
indicates the charger is ready to charge.
Caution: Each charging port can only charge one kind
of battery at the same time.
When using 12V lead acid battery
Using DC cable attaching to car battery
Error messages
When there is an error, the LED will blink red twice per second with an audible sound.
After ten times of blinking, the red LED will stay on and the digital LED will display the error code.
Error Error Message
-11- Dead cell or the voltage of the cell is either too high or too low for safe charging.
-22- The battery polarity is connected incorrectly.
-33- The battery connection is wrong.
-44- Short circuit or over current in the battery.
-55- The DC input voltage is either too high or too low.
12V 12V