Publicité
Les langues disponibles
Les langues disponibles
CORRECT CABLE WRAP - TEAR DROP
U-Clamp Distance
1 1/2 times tree Diameter
Course end
of cable
on bottom
4. TIGHTENING ZIPLINE
• Using the turnbuckle to tighten - inspect your initial installation work carefully and thoroughly. The
zipline cable can hold weight many times that of most riders. The loops, u-clamps and attachment trees
are the most likely to fail if not assembled correctly, and therefore should be inspected extra carefully
and often.
• Tune the zipline by twisting the center section of the turnbuckle to tighten.
• Tighten the line until it appears to be nearly level or straight. DO NOT OVER-TIGHTEN
•you can now remove your six small nails used to hold the cables in position during installation.
TREE/
POLE
Example: Tree Diameter = 35 cm, closest U-Clamp
after final tightening should be 50 cm from the tree
Third installed
U-shape
thread
U-Clamp
Washer
Thread cover
cap
INCORRECT - TOO TIGHT!
Second installed
U-Clamp
U-Clamp
8 cm between bolts
Place thread cover caps on each exposed thread
Figure 3
TREE/
POLE
First installed
U-Clamp
7
Publicité
