Télécharger Imprimer la page

fadini Elpro 37 DS Mode D'emploi page 15

Publicité

Les langues disponibles

Les langues disponibles

37
GB
ELECTRONIC BRAKE FUNCTION
ATTENTION:
In cases a motor with mechanical brake is used or a control board ELPRO 14 is replaced, the DIP-switch A
!
No.12 has to be in OFF.
Description
To enable the electronic brake function set the Dip-switch-A No. 12
in ON and adjust the electronic brake intensity by the selector in the figure.
The factory preset adjustments are suitable for most installations.
For a more precise regulation of the electronic brake, it is possible to set up various braking
parameters by following the advanced instructions bellow.
ADVANCED INSTRUCTIONS FOR THE ELECTRONIC BRAKE
ATTENTION: the electronic brake is to be enabled by putting the Dip-switch No.12 in ON
Function
Description
To adjust the braking duration it is necessary to put the Dip-Switch B
Braking time:
No.1 in ON and set the braking time by Trimmer T.FUN.
Once the calibration of braking duration is completed, put all
Dip-switches B in OFF.
To set the additional stop time after braking it is necessary to put the
Additional stop
Dip-switch B No.2 in ON and adjust the stop time by mean of trimmer
time after braking
T.FUN.
when safety
devices are
Once the calibration of additional stop time is completed put all
Dip-switches B in OFF.
activated:
N.W.: this function is enabled and adjustable even if the electronic
brake is disabled. It allows more time for the gate to reverse the
travel direction when safety devices as photocells or sensitive edges
are engaged, so as proper reverse movement is achieved, especially
for single-phase motors where high inertia is involved.
For setting working time of the electric lock or courtesy lamp connected
Electric lock:
to the 14-15 outputs, put the Dip-switch B No.3 in ON and adjust the
working time by mean of trimmer T.FUN.
In this mode, the trimmer T.FUN enables you adjust electric lock working
time from 0s to 5s in the first half of trimmer travel. In the second half
of trimmer travel it allows you connect a relé to 14-15 outputs for a
courtesy lamp working time control, adjustable from 30s to 5 min.
or Courtesy lamp:
Once the electric lock or courtesy lamp working time is set, put all
Dip-switches B in OFF.
SINGLE – THREE PHASE ELECTRONIC CONTROL BOARD WITH ELECTRONIC BRAKE FOR
DOUBLE-LEAF SLIDING GATE AUTOMATIC SYSTEMS WITH OR WITHOUT LIMIT SWITCHES
12Vac power supply output
14 15
for electric lock 15VA max or
relè for courtesy lamp control
Dip - Switch and trimmer of functions
DIP-SWITCH - A
ON
OFF
1 2 3 4 5 6 7 8 9 10 11
1 2
3
ELECTRONIC BRAKE
INTENSITY
Dip - Switch and trimmer of functions
Operations
I
II
T.FUN
0s - 2s
DIP-SWITCH - B
ON
OFF
1
2 3 4
Operations
I
II
T.FUN
0s - 3s
DIP-SWITCH - B
ON
OFF
1
2 3 4
Operations
I
II
T.FUN
DIP-SWITCH - B
5s
30s
ON
OFF
1
2 3 4
0s
5min
meccanica
FADINI
12
4 5
III
DIP-SWITCH - B
ON
OFF
1 2 3 4
III
DIP-SWITCH - B
ON
OFF
1 2 3 4
III
DIP-SWITCH - B
ON
OFF
1 2 3 4
page 15

Publicité

loading