Wolf EC2450TE/S Mode D'emploi page 9

Installation
Installation
1 Center the bottom trim in the opening.
2 Align the front edge of the bottom trim with the front of
the opening. Refer to the illustration below.
3 Align the holes on the bottom of each slide with the
studs on the trim, then place the slides on the bottom
trim.
4 Verify the distance between the slides is 18 1/2"
Refer to the illustration below.
5 If necessary, use the shim material provided, then
secure the slides to the cabinet with 12 screws per slide.
6 Extend the slides to full extension.
7 Place the unit on the slides.
Bottom trim alignment
.
(470)
1
18 / "
2
(470)
Slide installation
8 1 Rotate the leveling cams to level the front of the unit,
then push the locking tabs. Refer to the illustration
below.
9 2 Install and hand-tighten a screw from the bottom of
each slide to secure the unit to the slides.
10 3 Plug the power cord into the receptacle.
11 4 Place the cord into the clip at the top of the opening.
LEVELING
CAM
LOCKING
TAB
Level unit
wolfappliance.com | 9