Hansgrohe AXOR One 280 2-Jet 48481 1 Serie Instructions De Montage / Mode D'emploi / Garantie page 2

T EC HN I C A L I N FO RMATIO N
Max. flow rate
48481XX1
48482XX1
I NSTA LL ATI O N CO N SIDE R ATION S
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
⁄ Make sure that the entire fastening surface is even
and smooth (no protruding seams or tile offset), that
the finish of the wall is suitable to apply the product
and has no weak points.
⁄ This showerhead is for use with rough #35361181
(not included).
⁄ SPECIAL INFORMATION FOR AUSTRALIA
ONLY: This showerhead is for use with rough
#35361180 (not included)
⁄ 48481XX1ONLY: This showerhead is for use with
automatic compensating valves rated at 1.9 GPM
(7.2 L/min) or less.
2
E N G L I S H
2.5 GPM (9.5 L/min)
1.75 GPM (6.6 L/min)
⁄ 48482XX1 ONLY: This showerhead is for use with
automatic compensating valves rated at 1.3 GPM
(4.9 L/min) or less.
⁄ To prevent scald injury, the maximum output tem-
perature of the shower valve must be no higher than
120°F (49°C). In Massachusetts, the maximum
output temperature can be no higher than 112°F
(44°C).
⁄ The shower arm is intended only to hold the shower
head. Do not load it down with other objects!
⁄ Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.