I - Building In - Klimawatt Eurocave Compact 59 Série Mode D'emploi

Wall fixing of the cabinet
For large models, if the wine cabinet is not being built in, it is essential
to secure it to the wall to prevent it from tipping forward. You will find
all the necessary parts in the accessories bag supplied with the unit. For
installation (see diagram below):
1
Loosen the screws A .
2
Attach the bracket to the cabinet with the screws
B
3
Clip the nut to this bracket
C
to the cabinet).
Warning: make sure that the part is correctly clipped by
pulling upwards by hand. The clip must not come out.
1. Building in
A
Dimensions for solid, glass or full glass door:
A maxi A mini
059 832 816
259 1792 1776
259 :
It is essential that the unit inside which the cabinet will be fitted
has an opening at the top, at the back, measuring at least 540mm in length
and 50mm in width (see technical door diagram).
- I
4
NSTALLING YOUR WINE CABINET
A .
(preferably choose the hole nearest
B
G
F
C
D
A
B
E
B C
B C mini
Solid door 555 821
Glass door 549
Full glass 548
Solid door 572 1781
Glass door 566
Full glass 565
4
Preposition the wall bracket
for drilling the holes for the wall-mounting screws,
5
Drill the holes then attach the wall bracket
Warning: ensure that the wall fixing can withstand a tensile
force of 100 kg.
6
Tighten screw
G
there is contact between the wall bracket
Only full tightening of the screw will ensure correct fixing of the unit.
Repeat the installation on the other side of the cabinet.
D
A
Hinge without pin
B
Flush fitting hinge
C
Pillar (model 059 only)
D
No. 25 Torx screw
x6
(on the nut to determine the position
D
with suitable screws
D
with the washer until it is screwed fully in and
F
and the nut
D
560 min.
C
594
600 min.
E .
.
C
B
A
27
EN