Installation
Electrical Connections
Connecting the Monitor
● Route the power cable to the vehicle's
cigarette lighter socket 12/24V power
outlet. The cable must not interfere with
the safe operation of the vehicle.
● Insert the small 12/24 Volt DC plug of
the power cable into the right side of the
monitor.
● Plug the 12/24 Volt cigarette lighter plug
into the vehicle's cigarette lighter socket.
Connecting the Camera
WARNING
When connecting wires, ensure the circuit
is isolated by disconnecting the negative
terminal on the battery.
● Ensure correct polarity when wiring the
cables. RED + BLACK -.
● Ensure correct polarity when wiring.
● Wire connections and terminals must
be sealed and waterproof.
The Furrion Vision S Camera System can be
connected to an electrical power source via a
7 Way Connector.
Wiring to running lights: the camera will
activate when the running lights are switched
on.
Wiring to reverse lights: the camera will
activate when the vehicle engages reverse
gear.
Connects to
Connects to
Camera
Camera
Connects to
Camera
Consult the vehicle's service manual for
specific wiring color code.
7 WAY CONNECTION
7 WAY CONNECTION
When wiring this camera directly to a 12V
7 WAY CONNECTION
battery or converter in your RV, use an in-line
switch on the power cable to power on or off
your camera. This will enable this camera to
be used when parked without a tow vehicle
connected.
IN-LINE SWITCH
IN-LINE SWITCH
IN-LINE SWITCH
Connecting the Traffic Light
● Route the power cable to the vehicle's
12/24V running light. The cable must not
interfere with the safe operation of the
vehicle.
Tracffic light
Connects to
Connects to
12V/ 24V
12V/ 24V
Power Supply
Connects to
Power Supply
12V/ 24V
Power Supply
Running,
Running,
Reverse or
Reverse or
Auxiliary
Running,
Auxiliary
Lights
Reverse or
Lights
Auxiliary
Lights
ON/OFF
ON/OFF
ON/OFF
DC POWER SUPPLY
DC POWER SUPPLY
DC POWER SUPPLY
Connects to Vehicle
Running Light (brown wire)
Connects to Camera (red wire)
Grounding Wire (black wire)
19