Furrion FOS07TASK Manuel D'instructions page 12

Installation
5. Fix the mounting bracket onto the vehicle
wall using 2 flat self-tapping screws
provided. (Fig. 4)
NOTE: Make sure the "FURRION VISION
S" is facing up while installing.
Fig. 4
6. Align the monitor into the installed
bracket and push firmly until the dot
bullet locks into the monitor. (Fig. 5)
Fig. 5
Tabletop Installation
To prevent your monitor from fall damage
during driving, the tabletop mounting bracket
is designed with 4 non-slip pad attached
under the bracket.
1. Select a suitable mounting position where
you are going to secure your monitor.
2. Feed the supplied camera power cable
through the hole on back of the tabletop
bracket and insert into the monitor power
port. (Fig. 6)
12
Fig. 1
3. Align the dot bullet of the tabletop bracket
with the opening on back of the monitor
and push firmly until locked into place.
(Fig. 7)
Fig. 7
4. Rotate the monitor to adjust the visual
angle as needed.
Installing on Windshield
1. Clean the mounting area where you are
going to install the monitor with a cleaner
that does not leave a residue.
2. Remove the protective film from the
bottom of the suction cup.
3. Carefully position the suction cup on the
windshield and rotate the locking arm
downwards to stick securely. (Fig. 8)