Furrion FOS07TASK Manuel D'instructions page 16

Installation
12. Gently place the camera into the bracket
and secure with 4 flat self-tapping screws.
Make sure the connections and the
camera antenna are secured tightly.
(Fig. 20)
Fig. 20
Left and Right Camera Installation
(if purchased)
A traffic light must be installed together
with the camera. For best performance, we
recommend a Furrion traffic light is selected.
1. Select a suitable position on the side of
the vehicle wall where you would like to
install the camera.
2. Remove the lens cover by scratching the
slot on the side of the traffic light.
(Fig. 21)
Fig. 21
16
3. Remove the two screws holding the
decorative part using a Phillips-head
screwdriver and set aside. (Fig. 22)
Fig. 22
4. Pull to remove the decorative part from
traffic light and save in a safe place in
case of future use. (Fig. 23)
Fig. 23
5. Secure the traffic light base on the vehicle
wall using the four flat self-tapping
screws (quad drive flat head #6 x 3/4" self-
drilling wood screw). (Fig. 24)
Fig. 24