Installation; What's In The Box; Monitor Installation - Furrion FOS07TASK Manuel D'instructions

Installation

COMPLETELY READ THIS MANUAL BEFORE
INSTALLATION
NOTE: We have included all of the items
needed for most standard installations, but
all vehicles are different. We recommend
you review your vehicle completely before
starting.

What's in the Box

Make sure you have all the following items
included in the packaging. If any item is
damaged or missing, contact your dealer.
● Monitor x 1
● Windshield Stand x 1
● Interior Table Stand x 1
● Monitor Power Cable x 1
● Camera (different by model)
● Warranty Card x 1
● Instruction Manual x 1
NOTE: The contents included may be
different based on the kit you purchased.
Please take the actual product as standard.

Monitor Installation

Choose a monitor location in your vehicle that
does not block your view and complies with
local laws for safe driving. Do not place in an
area where it might interfere with driving.
WARNING: To prevent the risk of electric
shock or fire, during installation, remove the
key from the ignition and isolate the 12V or
24V power source.
Wall-mount Installation (sold
separately)
CAUTION: Ensure there are no electrical
cables, gas lines, pipes or other important
parts behind the wall where the drill holes
will be.
1. Select a suitable mounting position where
you are going to locate your monitor.
2. Mark a basic outline on the wall using the
provided mounting bracket. (Fig. 1)
Fig. 1
3. Drill a 5/8" hole on the vehicle wall where
the mounting bracket wire feeds in using
a 5/8" hole saw. (Fig. 2)
Fig. 2
4. Feed the bare end of the mounting
bracket wire into the hole and connect to
the supplied camera power cable. (Fig. 3)
NOTE: Connect black to black, red to red.
Red is positive "+" and black negative "-".
Fig. 3
11