EyeVac Home Touchless Sensor Activated Vacuum Manuel De L'utilisateur page 4

To maintain optimal performance, the Dirt Filter will need cleaning whenever the suction is not strong. The Dirt Filter
must be clean and free of elements, which might hinder the flow of air.
1. Turn the Power Button to the OFF position and unplug the unit.
2. Pull the Collection Bin outward from the front of the Bin Cavity. Grasp the Collection Bin Grip firmly and lift it out
and away from the EYEVAC HOME Main Unit. Locate the Dirt Filter Handle.
3. Remove the Dirt Filter by grasping the Dirt Filter Handle and turning counter-clockwise to the "unlock" position. Pull
the Filter straight up and out of top of the Collection Bin (See Figure 3.). Rinse under running water to clean.
4. IMPORTANT! Dry thoroughly before use.
5. Slide the Dirt Filter back into the top of the Collection Bin. Rotate clockwise to the "lock" position. Put the collection
bin back into place.
IMPORTANT! NEVER OPERATE THE EYEVAC HOME WITHOUT THE DIRT FILTER PROPERLY IN PLACE.
Figure 3
CLEANING THE MICRO EXHAUST FILTER HOLDER
1. The Micro Exhaust Filter Holder slides up and out of its housing on the side of the unit.
2. Gently pull the Filter out of the Filter Holder. (See Figure 4)
3. Tap Filter gently against trash container to free and eliminate excess dirt and debris. (See Figure 5)
4. To clean the Filter, wash in mild soap and water; rinse and dry thoroughly before using the unit.
5. If a new Filter is needed, replace with standard HEPA HF4 filter cartridges. Make sure that it fits snugly in the Filter
Holder. Replacement Filters are available through the Customer Service Department.
6. Slide the Holder back into the unit with the Filter facing outwards.
IMPORTANT! NEVER OPERATE EYEVAC HOME WITHOUT THE MICRO EXHAUST FILTER AND FILTER HOLDER
PROPERLY IN PLACE.
The Collection Bin should be washed periodically.
1. Wash the Bin in warm water using a mild soap. Avoid harsh or abrasive cleaners or sponges. Rinse thoroughly. TO
AVOID DAMAGE, DO NOT PLACE COLLECTION BIN IN THE DISHWASHER.
2. Let it air dry. Make sure the Collection Bin is completely dry before putting it back into the EyeVac Home
3. Insert the assembled Collection Bin following the instructions outlined in the USER MAINTENANCE
INSTRUCTIONS on page 3.
IMPORTANT NOTES
Other than cleaning the Dirt Filter and replacing the Micro Exhaust Filter Holder, as described in this Manual, this
Automatic Vacuuming Dust Bin is not user serviceable. There are no user serviceable parts inside the unit.
Servicing by our Authorized Service Center is required to avoid damage to internal components.
1. Unplug the unit and clean Collection Bin and all Filters before storing.
2. Store the EYEVAC Home indoors, in a clean, dry place.
3. Never store EYEVAC Home while it is still plugged in. Never wrap cord tightly around the appliance, use the Cord
Storage area on the back of the EYEVAC Home unit. Do not put any stress on the cord where it enters the unit,
as it could cause the cord to wear and break.
WARNING! TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT USE OUTDOORS OR ON WET
SURFACES.
CLEANING THE DIRT FILTER
Micro
Exhaust
Filter Holder
Figure 4
CLEANING THE COLLECTION BIN
STORAGE
Figure 5