EyeVac Home Touchless Sensor Activated Vacuum Manuel De L'utilisateur page 3

Figure
sensor is reflective and light sensitive so performance will
diminish with black broom bristles and/or low light conditions.
1. Remove EYEVAC HOME from packaging and set upright on any non-carpeted flooring. Remove packing tape from
Micro Exhaust Filter on the side of the unit. 2. Plug unit into any standard 120V(US)/220-240V(EU). AC electrical outlet 3.
Depress the Power Button to the MAN position for manual operation or to the AUTO position for automated use. The
POWER Indicator Light will illuminate when the Power Button is in either of these positions. Your EYEVAC HOME is now
ready for use.
NOTE: EYEVAC HOME cannot operate when the power button is in the OFF position.
1. Turn the Power Button to the MAN position for manual operation or to the AUTO position for automated use.
The POWER Indicator Light will illuminate when the Power Button is in either of these positions
2. In the MANUAL Mode, sweep debris towards the Inlet at the Base of the unit, press the Manual Activation
Button and let EYEVAC HOME vacuum the debris through the Inlet and into the Collection Bin.
NOTE:
1. The MANUAL Mode will run for 7.5 seconds. Depending on the amount of debris, it may be necessary to press
the Manual Activation Button more than once.
2. When the unit is set to the AUTO position, sweep debris towards the Inlet at the Base of the unit and the EYEVAC
Sensors will detect the debris and automatically initiate a seven second vacuum cycle. EYEVAC Home will vacuum
the debris through the Inlet and into the Collection Bin without you ever having to bend over or touch the dirt.
3. Use the Manual Activation Button to begin vacuuming in either the MANUAL or AUTO Modes.
4. As debris accumulates, the Collection Bin will need to be emptied. The Collection Bin Indicator Light lets you
know when it is time to empty the Collection Bin.
1. To empty the EYEVAC HOME Collection Bin, turn the Power Button to the OFF position and unplug the
unit.
2. Pull the Collection Bin outward from the front of the Bin Cavity. Grasp the Collection Bin Handle firmly and lift it out
and away from the EYEVAC HOME Main Unit.
3. Holding the Collection Bin firmly with one hand, grasp the Collection Bin Lid Handle with the other hand and pull
the Lid straight up and out to remove.
4. Turn the Collection Bin upside down over a trash can. Make sure you empty all dirt and debris from inside and
below the Bin. To ensure that all the dirt spills out, tap the side of the Collection Bin gently against the edge of the
trash can. Re-attach the Collection Bin Lid to the top of the Collection Bin.
5. Clean Sensors, Dirt Inlet area and Collection Bin Cavity with a damp rag or towel.
6. Insert the assembled Collection Bin with Lid fitted snugly into position bottom-first into the Collection Bin Storage
Cavity at the front of the EYEVAC HOME. The 2 grooves in the bottom of the Bin fit easily over the rod in the front of
the unit. Grasp the Collection Bin Grip and lock the Collection Bin back into position. HEALTH TIP
If you suffer from allergies or asthma, take the Collection Bin outdoors to empty. As you empty the dirt into the trash
can, gently tap the Collection Bin against the side of the can to remove loose debris.
DESCRIPTION OF EYEVAC HOME
Figure
Collection Bin Full Detector
Status Indicator Light
Collection Bin
EyeVac Sensors
the
Dirt Inlet
BEFORE USING FOR THE FIRST TIME
OPERATING INSTRUCTIONS
USER MAINTENANCE INSTRUCTIONS
Collection Bin Handle
Filter Holder
Filter
Collection Bin
Dirt Filter
Figure
Filter