Foppapedretti CLEVER Instructions De Montage page 24

shown in the illustration above.
Insert the vehicle strap into the guide marked in red and adjust the belts to
the desired position. Finally, fasten the belts of the vehicle. Make sure that the
diagonal and lap belts are underneath the armrest.
•
The tighter the belts, the more protected your child will be. If your child
feels that they are too tight, check whether you need to adjust the straps by
making them higher. The distance between the seat belt loop and your child's
shoulders must be between 0.5 and 2.5 cm.
•
The seat belt should never be twisted.
•
If the tongue does not click when inserted into the buckle, unclip it and try again.
•
Make sure that the lap belt is positioned as low as possible so that the sides
are properly secured.
•
Do not alter or modify the seat without prior authorisation by the approval
authority.
•
Installing the car seat without following the instructions carefully may cause
hazards.
•
The vehicle's seat belt buckle must be positioned so that it does not touch the
main anchoring point of the car seat. If the seat belt buckle is too long, the car
seat is not suitable for the seat chosen. Please contact the manufacturer if you
have any queries.
•
Do not use anchoring points different to those indicated in this manual and
marked visually on the restraint device.
•
The instructions for use must be kept in the storage compartment of the car seat.
•
DO NOT use this child restraint device after 10 years from the date of
manufacturing.
• ENGLISH •
HOW TO SECURE YOUR CHILD
24