Foppapedretti CLEVER Instructions De Montage page 23

• ENGLISH •
HOW TO SECURE YOUR CHILD
Checking the correct height of the headrest (E)
Before use, it is recommended that you adjust the car seat headrest by lifting it up
2 cm, so that it is in the correct position, to ensure maximum safety.
To make sure that you have adjusted the headrest to the correct height, check
that the loop of the belt is placed slightly above the child's shoulders (at a
distance of between 0.5 and 2.5 cm). You can adjust the height of the headrest by
holding the backrest with one hand and pulling the headrest upwards (or pushing
it down) with the other, gripping the upper part. You will hear a "click" when it is
positioned at the desired height.
Removing the backrest from the booster (G)
Push the backrest (and the headrest) downwards until you feel some resistance.
Gently push the backrest until it is completely lowered (G1), and then remove it
by pulling the hooks out from the booster openings (G2).
Installing the booster (H)
Position the seat belt around the child. Pass the lap belt under both armrests
(following the directions shown in red on the booster). Insert the tongue into the
seat belt buckle (H1) and tighten the lap belt so that it fits closely (H2).
Pass the strap back under the armrest and then over your child's shoulder. For
greater safety: pull the strap upwards 13 tightly (H2). Make sure that the belt is
not twisted (I).
Loop for the booster strap (J)
Attach the belt adapter to the base, as shown in the illustration. Follow the arrow
to adjust the belt to the desired length.
IMPORTANT: When used alone as a booster, it is important to remember that the
position of the strap guide depends on the position of the vehicle's seat belts, as
23