Publicité
Les langues disponibles
Les langues disponibles
AXC-2036DF
Order Number 18.4560
ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS ELECTRONICS FOR SPECIALISTS
HD Surveillance Camera
These instructions are intended for installers of
video surveillance systems. Please read the instruc-
tions carefully prior to installation and keep them
for later reference.
1
Applications
This high-resolution colour camera is specially designed for
use in video surveillance systems (CCTV). The video formats
HD-TVI, HD-CVI and AHD support transmission of high-
resolution analog video signals (1080p) via standard coax-
ial cables with a maximum length of 300 m. Alternatively,
the video signal output can be switched to composite
video signal (CVBS).
The rugged metal housing of the camera is weath-
erproof (IP 66) and therefore also suitable for outdoor
applications. Due to the swivelling lens (3-axis rotation),
the camera is also suited for wall mounting. The camera
features include automatic white balance, digital noise
suppression and other functions to be configured via
OSD menu. The menu can only be remote-controlled
by means of a video recorder with COC protocol. In the
dark, the IR LEDs will illuminate a surveillance zone of up
to 20 m, the IR filter will be deactivated and the camera
will switch to B/ W mode.
2
Important Notes
The camera corresponds to all relevant directives of the
EU and is therefore marked with
.
•
Protect the camera against extreme temperatures
(admissible ambient temperature range: –10 °C to
+50 °C).
•
When cleaning the housing, never use aggressive de-
tergents or chemicals.
•
No guarantee claims for the camera and no liability for
any resulting personal damage or material damage will
be accepted if the camera is used for other purposes
than originally intended, if it is not correctly installed,
or if it is not repaired in an expert way.
If the camera is to be put out of operation defin-
itively, take it to a local recycling plant for a dis-
posal which is not harmful to the environment.
MONACOR INTERNATIONAL GmbH & Co. KG • Zum Falsch 36 • 28307 Bremen • Germany
3
Installation
1) Make a test run first to find the best mounting lo-
cation.
2) Use the key provided to release the four screws on
the dome (10) and remove the dome from the base
(1). To avoid scratches, leave the protective film on
the dome during installation.
CAUTION Never touch the lens with your fingers.
For cleaning the lens, only use optical lens cleaners.
3) At the mounting location (e. g. wall or ceiling), drill
four holes for fixing the base (1) and, if necessary,
drill a hole for the connection cable [alternatively, the
cable can be guided through the cable inlet (7) on
the side of the base]. A drill template is supplied as
an aid. A rubber plug (6) is provided to seal the cable
inlet on the side of the base if the inlet is not used.
Fasten the base by means of the screws provided.
4) Connect the BNC connector VIDEO OUT (3) to the
input of a video recorder (e. g. AXR series from MO-
NACOR) or to the input of a monitor.
To select the required signal format: Open the pro-
tective cap of the switches VIDEO FORMAT (4) and
set the switches as shown in the figure. Then replace
the cap.
5) Connect a regulated 12 V power supply unit with a
permanent rating of 350 mA to the inline jack POWER
(5). A low-voltage plug 5.5 / 2.1 mm (outside / inside
diameter) is required. Always observe the correct
polarity (centre contact = +).
CAUTION The infrared LEDs (8) will switch on when
darkness falls. When setting up the camera, never
look directly into the lit infrared LEDs from a close
range. The infrared light may cause eye irritation.
However, the infrared radiation is far below the emis-
sion limit and rated risk-free according to EN 62471.
6) For outdoor installation please note:
The connections (3 – 5) and the cable splitter (2) are
not weatherproof; protect them accordingly.
7) Switch on the video recorder and the monitor con-
nected and adjust the support of the camera to
align the camera (9) to the surveillance zone. Make
sure that the cable connections are neither stretched
nor torn.
8) After all adjustments have been made, place the
dome onto the base and fasten it by means of the
four screws.
4
Settings via OSD Menu
The camera settings can be changed via an OSD menu
which is operated via PTZ remote control from the video
recorder. The control is made by means of the COC pro-
tocol (Coax) via the video cable.
To activate the OSD menu, send the control command
"Iris +". The main menu will appear:
MAIN MENU
1. LENS
MANUAL
↲
2. EXPOSURE
3. BACKLIGHT
OFF
↲
4. DAY&NIGHT
EXT
↲
5. NR
↲
6. SPECIAL
↲
7. ADJUST
↲
8. EXIT
SAVE&END
To select a menu item, make control commands for the
vertical movement (Tilt: , ); to change the value or
to select an option, make control commands for the
horizontal movement (Pan: , ). When the symbol
appears behind a menu item or an option, the command
"Iris +" (corresponding to "Enter") can be used to call
up a submenu or to activate a function.
All setting options can be found in the table on the
back of these instructions. These instructions refer to the
preset English menu; to change the menu language, go
↲
to
.
6. SPECIAL
2. LANGUAGE
To exit the menu, use or in the line
EXIT
↲ (to save the changes) or
the option
SAVE&END
NOT SAVE
(to cancel the changes) and confirm with "Iris +".
To reset all settings to the factory settings, use or
↲ and confirm
in the line
to select the option
EXIT
RESET
with "Iris +". The menu language selected will remain
the same after a reset.
Copyright
by MONACOR INTERNATIONAL. All rights reserved.
©
5
Specifications
Image sensor: . . . . . . . . . . . CMOS chip, 9 mm (10⁄28 ")
Number of pixels: . . . . . . . . 1920 × 1080 max.
Resolution: . . . . . . . . . . . . . 1080P/ 25
Colour modulation system: . PAL
Lens: . . . . . . . . . . . . . . . . . . 3.6 mm /1 : 1.2
Viewing angle: . . . . . . . . . . 80°
Electronic shutter: . . . . . . . . 1/25 – 1⁄50 000 s
Video output: . . . . . . . . . . . 1 V (pp) / 75 Ω
IR LEDs, range: . . . . . . . . . . 16 LEDs, 20 m
Power supply: . . . . . . . . . . . ⎓ 12 V ±10 %, 350 mA
Ambient temperature: . . . . −10 °C to +50 °C
IP rating: . . . . . . . . . . . . . . . IP 66
⌀
Dimensions: . . . . . . . . . . . .
117 mm × 90 mm
Weight: . . . . . . . . . . . . . . . 350 g
↲
to select
↲
Subject to technical modification.
A-1769.99.03.01.2019
Publicité
