Kyocera Senco Smart BoardMaster SCN49XP Mode D'emploi page 7

1.7 Switch the clamp distance SHORT / LONG
Press a toggle switch.
y Distance SHORT: the indicator of the switchover switch is off.
y
Distance LONG: the indicator of the changeover switch is on.
1.8 Triggering
Press a trigger, and the adjusted clamp distance is fixed.
If the device is moved too fast, no releases and the ring
lights of the Shift button flashes quickly.
y Caution: Never move the tool over the work piece in the
open position
1.9 Adjusting the telescopic arm
y Loosen the telescopic arm
y Adjust the telescopic arm to the desired length.
y Tighten the sleeve adjuster on the telescopic arm.
1.10 Setting the drive depth
y
Loosen the four screws KDN0917
y
Loosen the locknut the adjusting screw
y Adjust the drive depth of the adjusting screw. Rotate it
out downward.
y Pull the locknut and The four screws KDN0917 firmly.
KDN0917
1.11 Setting correct spacing
Guidance for setting fixed Distances along the edge of
Application
y Loosen the locking lever
y Pull the side stop in the preferred distance (scale)
y The stop will result in a continues distance in relation to
the desired distance. For distances of 90-140mm can
change the guide over 50mm by screwing into 2 tapped
holes (scale +50)
y
Set the guide roller with the handle downwards.
Slotted hole
Guide
Stop
Scale
Locking lever
Adjusting screw
Adjusting screw
Insertion depth
Insertion depth
Laser line
(staple center)
Handle
Edge guide roll
Side stop
1.12 Removing the tool
Telescopic arm
Telescopic arm
Coilnailer
Coil nailer
Trigger air
hose nipple
Trigger air hose nipple
Expansion:
y Disconnect the unit from the compressed air supply!
y
Adjust the telescopic arm vertically.
y
Pull both air hoses off the hose nipples
y
Rotate the driver by lifting the head
y Press the locking pin down with a suitable tool
y Pull the drive unit out of the holder
Mounting:
y Press the locking pin down with a suitable tool
y Place the drive unit with the mounting bolt in the holder
y Place both air hoses on the hose nipple
WORK WITH GUIDE RAILS
2.1 The roadmap is for working with standard
designed guide rails.
y Set up the pathology the guide rail, so that a score of the
rail guides over the guide bar.
y
When using a Festool rail use the wide notches, with a
Maffel rail the narrow notches.
y
To change over, turn the screws KDN0706, turn the rail
guide around, re-tighten the screws.
7
Locking pin
Locking pin
Coilnailer connecting pin
Coil nailer connecting pin
Trigger air hose nipple
Trigger air hose nipple
(Festool / Maffel)
KDN0706
Sliding
guide
Guide notch
Wide notch - Festool guide rail
Guide rail
Thin notch - Mafell guide rail
EN